Interfaz traducida. El contenido técnico sigue en inglés.

Diagnóstico / Códigos de avería

P0315

Cylinder Misfire / Combustion Fault

Advertencia — revísalo prontoEngineOM642 V6 3.0L Diesel · VS30 / W907 (2019–Present)

P0315 is a cylinder misfire / combustion fault on the Mercedes Sprinter VS30 (OM642 3.0L V6 diesel).

P0315 on the Mercedes Sprinter VS30 falls under the cylinder misfire / combustion fault group for the OM642 V6 diesel. The ECU sets this code when it detects an out-of-range condition in this system. Use the symptoms, common causes, and diagnostic steps below as a starting point, and always read the live data and freeze-frame for this specific code before replacing parts. If you're searching for the P0315 Mercedes Sprinter fix or P0315 VS30 / OM642 information, start with a full scan to capture any related codes stored at the same time.

  • Rough idle or shaking, especially when cold
  • Hesitation, stumbling, or power loss
  • Check engine light (may flash under heavy misfire)
  • Hard starting
  • Increased smoke or fuel smell

Advertencia — revísalo pronto

P0315 is a cylinder misfire / combustion fault on the Mercedes Sprinter VS30 (OM642 3.0L V6 diesel).

  • Worn, clogged, or leaking fuel injector (cylinder-specific)
  • Low fuel rail pressure / delivery fault
  • Faulty glow plug (cold-start misfire)
  • Low or uneven cylinder compression
  • Air ingress in the fuel system
  • Scan and record all codes, noting which cylinder(s) are flagged.
  • Read live misfire counters per cylinder.
  • Perform an injector return (back-leakage) test on the affected cylinder.
  • Verify rail pressure tracks the commanded value.
  • Test glow plugs for cold-start misfires.
  • If fuel and glow systems are good, perform a compression/leak-down test on the affected cylinder.
  • Replace a worn, clogged, or leaking injector on the affected cylinder.
  • Restore fuel rail pressure by fixing the supply or pump fault.
  • Replace a failed glow plug causing cold-start misfire.
  • Purge air ingress from the fuel system and reseal connections.
  • Address low/uneven compression with mechanical repair if confirmed.